Replacing CRUs

go to back go to home menu  

Replacing the M.2 solid-state drive

Attention

Do not open your computer or attempt any repairs before reading the Important Product Information Guide.

  1. 1

    Remove the computer cover. For details, see Removing the computer cover.

  2. 2

    Remove the front bezel. For details, see Replacing the front bezel.

  3. 3

    Pivot the drive bay assembly upward. For details, see Pivoting the drive bay assembly upward and downward.

  4. 4

    Remove the M.2 solid-state drive heat sink.

    Removing the M.2 solid-state drive heat sink
  5. 5

    Depending on your computer model, refer to one of the following to replace the M.2 solid-state drive.

    • Type 1


    1. 1 Pulling out the stopper
    2. 2 Removing the M.2 solid-state drive
    3. 3 Installing the M.2 solid-state drive
    4. 4 Inserting the stopper
    • Type 2


    1. 1 Pulling out the stopper
    2. 2 Removing the M.2 solid-state drive
    3. 3 Installing the M.2 solid-state drive
    4. 4 Inserting the stopper
  6. 6

    Install the M.2 solid-state drive heat sink.



    1. 1 Installing the M.2 solid-state drive heat sink
    2. 2 Securing the M.2 solid-state drive heat sink
  7. 7

    Reinstall the removed parts. To complete the replacement, see Completing the parts replacement.