Optical drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Read this first: Important safety information.

Depending on your computer model, the following devices might be installed in the flex bays:

Note: The following instructions on how to remove or install an optical drive also apply to other supported devices in the flex bay.

To remove or install an optical drive, do the following:

Prepare your computer. See Preparing your computer and removing the computer cover.
Remove the front bezel. See Front bezel.
If you are removing an optical drive, do the following:
1. Disconnect cables from the rear of the optical drive, press the release button 1, and then slide the optical drive out of the chassis.
  Figure 1. Removing the optical drive
2. Remove the optical-drive retainer from the left side of the optical drive.
If you are installing an optical drive, do the following:
1. Locate the optical-drive retainer from the left side of the computer. Push the retainer downwards to unlock the retainer. Then lift the retainer out of the chassis.
  Figure 2. Removing the optical-drive retainer from the computer
2. Install the optical-drive retainer onto the left side of the new optical drive.
  Figure 3. Installing the optical-drive retainer
3. If necessary, remove the plastic panel in the front bezel for the desired flex bay.
4. Slide the new optical drive into the flex bay from the front of the computer until the optical drive snaps into position.
  Figure 4. Installing the optical drive
5. Connect the cables to the rear of the new optical drive.
  Figure 5. Connecting the cables to the rear of the new optical drive
Reinstall the front bezel. See Front bezel.

What to do next:

To work with another piece of hardware, go to the appropriate section.
To complete the installation or replacement, go to Completing the parts replacement.