Replacing FRUs
Attention
Do not open your computer or attempt any repairs before reading the Important Product Information Guide.
Although there are no moving parts in your computer after the power cord has been disconnected, the following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
Caution
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.
Remove any media from the drives and turn off all connected devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the computer cover is facing up.
Remove the computer stand. For details, see Replacing the computer stand.
Remove the computer cover. For details, see Removing the computer cover.
Remove the system board shield. For details, see Replacing the system board shield.
Remove the VESA mount bracket. For details, see Replacing the VESA mount bracket.
Disconnect power supply assembly cables from the power cord connector and system board.
Replace the power supply assembly.
Connect the new power supply assembly cables to the power cord connector and the system board.
Reinstall the removed parts and computer cover, and then reconnect the cables. For details, see Completing the parts replacement.