Power supply assembly

Attention:

Do not open your computer or attempt any repair before reading and understanding the Read this first: Important safety information.

Although there are no moving parts in your computer after the power cord has been disconnected, the following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.

CAUTION:
This label indicates hazardous moving parts nearby and warns users and servicers to keep fingers and other body parts away.

Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury, seek medical care immediately.

DANGER
This label instructs users not to open with tools because hazardous voltages, currents, and/or energy levels are present inside any component or near any area that has this label attached.

Disconnect all power cords from electrical outlets before removing the computer cover or any part that has the above label attached.

To remove and install the power supply assembly, do the following:
  1. Prepare your computer. See Preparing your computer and removing the computer cover.

  2. Locate the power supply assembly. See Computer components.

  3. Pivot the handle 1 at an angle of about 90 degrees as shown. Then, pull the handle as shown to remove the power supply assembly from the chassis.
    Figure 1. Removing the power supply assembly
    Removing the power supply assembly

  4. With the handle 1 open, slide the power supply assembly into the power supply assembly bay until it snaps into position. Pivot the handle to the closed position to ensure that the new power supply assembly is fully installed into position.
    Figure 2. Installing the power supply assembly
    Installing the power supply assembly

What to do next: