Keyboard

Prerequisite

Before you start, read Important safety information and print the following instructions.

Replacement procedure

Note: You might be instructed to slide the keyboard frame forward or backward in some of the following steps. In this case, ensure that you do not press or hold the keys while sliding the keyboard frame. Otherwise, the keyboard frame cannot be moved.

  1. Disable the built-in battery. See Disable Fast Startup and the built-in battery.

  2. Turn off the computer and disconnect the computer from ac power and all connected cables.

  3. Take the tool out of the new keyboard package. Insert the tabs a and b into the slot between the TrackPoint buttons and the trackpad 1. Slightly pivot the tool downward 2 to release the left and right TrackPoint buttons. Then, remove the two Trackpoint buttons 3.
    Illustration showing how to reveal the screw heads beneath the keyboard frame.

  4. Loosen the screws that secure the keyboard.
    Illustration showing how to remove the screws securing the keyboard.

  5. Insert the tabs c and d into the two dents near the two screw heads as shown.
    Illustration showing how to release the keyboard.

  6. Pivot the tool in the direction as shown to release the keyboard 1. Push the keyboard in the direction as shown by arrows 2 to release the latches from the keyboard bezel.
    Illustration showing how to release the keyboard.

  7. Pivot the keyboard slightly upward 1 and then turn over the keyboard 2.
    Illustration showing how to turn over the keyboard.

  8. Put the keyboard on the palm rest as shown and detach the connectors. Then, remove the keyboard.
    Illustration showing how to detach the connectors.

  9. Attach the connectors and then turn over the keyboard.
    Illustration showing how to attach the connectors and turn over the keyboard.

  10. Insert the keyboard into the keyboard bezel as shown. Ensure that the top edge of the keyboard (the edge that is close to the display) is under the keyboard bezel.
    Illustration showing how to insert the keyboard.

  11. Slide the keyboard in the direction as shown. Ensure that the latches are secured under the keyboard frame.
    Illustration showing how to pull the keyboard back to normal position.

  12. Tighten the screws to secure the keyboard.
    Illustration showing how to install the screws.

  13. Take the new TrackPoint buttons out of the new keyboard package. Install the TrackPoint buttons as shown.
    Illustration showing how to install the new buttons.

  14. Connect the ac power adapter and all disconnected cables to the computer.

Parent topic: Replace a CRU


<© Copyright Lenovo 2020.>