Connect the cable from the Ethernet connector to the RJ45 connector of the hub.
Enable the Ethernet LAN feature in the Setup Utility program.
Click the Start button to open the Start menu.
Click
.View Control Panel by Large icons or Small icons, and then click
.Right-click the Ethernet LAN adapter icon and click Enable.
Update or reinstall the Ethernet LAN driver. See Keeping your computer current.
Install all networking software that is necessary for your network environment. Check with your LAN administrator for the necessary networking software.
Set the same duplex for the switch port and the adapter. If you configured the adapter for full duplex, ensure that the switch port is also configured for full duplex. Setting the wrong duplex mode might degrade performance, cause data loss, or result in lost connections.
Solution:
Connect the network cable to the Ethernet connector using Category 5 wiring and a 100 BASE-T hub/switch (not 100 BASE-X).
Try another cable.
Set the link partner to auto-negotiate.
Set the switch to be 802.3ab-compliant (gigabit over copper).
Solution:
Enable the Wake On LAN feature in the Setup Utility program.