PCIe card

Attention: Do not open your computer or attempt any repair before reading and understanding the Read this first: Important safety information.

Your computer has one PCIe x1 card slot, one PCIe x16 card slot (negotiable link width x4), and one PCIe x16 graphics card slot (graphics card available on some models).

To remove or install a PCIe card, do the following:
  1. Prepare your computer. See Preparing your computer.

  2. Locate the PCIe card slot. See Computer components.

  3. If the PCIe card is held in place by a retaining latch, press the retaining latch a as shown to disengage the latch.
    Figure 1. Disengaging the card retaining latch
    Disengaging the card retaining latch

  4. To remove a PCIe card, do the following:

    1. Rotate the PCIe card retainer to the open position.
      Figure 2. Rotating the PCIe card retainer
      Opening the PCI card latch

    2. Grasp the old card and gently pull it out of the slot.
      Figure 3. Removing a PCIe card
      Opening the PCI card latch

  5. To install a new PCIe card, do the following:
    1. Remove the new PCIe card from its static-protective package.

    2. If necessary, remove the appropriate metal slot cover on the rear of the chassis.

    3. Install the new card into the appropriate slot on the system board. See Parts on the system board.
      Note: If you are installing a PCIe x16 graphics card, ensure that the memory-slot retaining clips are closed before you install the card to avoid any interference during the installation.
      Figure 4. Installing a new PCIe card
      Installing a PCI card

    4. Rotate the PCIe card retainer to the closed position.
      Figure 5. Rotating the PCIe card retainer
      Installing a PCI card

What to do next: