Prerequisite
Before you start, read Important safety information and print the following instructions.
Note: Do not remove the base cover assembly when
your computer is connected to ac power. Otherwise, there might be
a risk of short circuits.
Replacement procedure
Disable the built-in battery. See Disable Fast Startup and the built-in battery.
Turn off the computer and disconnect the computer from ac power and all connected cables.
Close the computer display and turn the computer over.
- Loosen the screws that secure the base cover assembly 1, pry up the latches 2, and then remove the base cover assembly 3.
- Install the new base cover assembly in place 1 and ensure that the latches of the base cover assembly are secured in place 2. Then, tighten the screws 3.
Turn the computer over. Connect the ac power adapter and all disconnected cables to the computer.
Troubleshooting
If the computer does not start up after you reinstall the base cover assembly, disconnect the ac power adapter and then reconnect it to the computer.