Memory module shielding cap

Follow the instructions to replace the memory module shielding cap.

Before you start, read Generic Safety and Compliance Notices.

Attention: Do not touch the contact edge of the memory module. Otherwise, the memory module might get damaged.
For access, do the following:

  1. Disable the built-in battery. See Disable the built-in battery.

  2. Turn off the computer and disconnect the computer from ac power and all connected cables.

  3. Close the computer display and turn over the computer.

  4. Remove the base cover assembly. See Base cover assembly.

Part location
  1. Remove the memory module shielding cap as shown below.
    ThinkPad T14 Gen 5 and ThinkPad P14s Gen 5 AMD
    Illustration showing how to remove the memory module shielding cap

    ThinkPad T16 Gen 3
    Illustration showing how to remove the memory module shielding cap

  2. Install the memory module shielding cap as shown below.
    Note:Ensure that the arrows on the memory module shielding cap point upwards to the direction of the thermal fan assembly. Otherwise, the memory module shielding cap cannot be installed correctly.
    ThinkPad T14 Gen 5 and ThinkPad P14s Gen 5 AMD
    Illustration showing how to install the memory module shielding cap

    ThinkPad T16 Gen 3
    Illustration showing how to install the memory module shielding cap

Parent topic: Replace a CRU

<© Copyright Lenovo 2023.>