M.2 solid-state drive

Follow the instructions to replace the M.2 solid-state drive.

Attention:

If you replace a M.2 solid-state drive, you might need to install a new operating system. For details on how to install a new operating system, see Install a Windows operating system and drivers.
If your computer is installed with the color profiles, you need to reinstall the color profiles after installing a new operating system, see Use the factory color calibration feature (for selected models).

The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of data.

When handling the M.2 solid-state drive, observe the following guidelines:

Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent changes or replacement.
Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
Do not apply pressure to the M.2 solid-state drive.
Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state drive might get damaged.
Do not subject the M.2 solid-state drive to physical shocks or vibration. Put the M.2 solid-state drive on a soft material, such as cloth, to absorb physical shocks.

For access, do the following:

Disable the built-in battery. See Disable the built-in battery.
Turn off the computer and disconnect the computer from ac power and all connected cables.
Close the computer display and turn over the computer.
Remove the base cover assembly. See Base cover assembly.

Part location