Power supply assembly

Prerequisite

Before you start, read Generic Safety and Compliance Notices, and print the following instructions.

Although there are no moving parts in the computer after the power cord has been disconnected, the following warnings are required for your safety.


This label indicates hazardous moving parts nearby and warns users and servicers to keep fingers and other body parts away.

Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury, seek medical care immediately. Never remove the cover on a power supply or any part that has the following label attached.

Attention/Caution/Danger icon 1 Attention/Caution/Danger icon 2

Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.

For access, do the following:
  1. Remove these parts in order, if any:

  2. Disconnect the power supply assembly cables from the system board.

Removal steps


Remove the power supply assembly

Screw (quantity)

Torque

#6 - 32 x L8, Hex Head (3)

5.0 ± 0.5 lb/in
Parent topic: CRU replacement

<© Copyright Lenovo 2023.>